It’s the same with bikes as it is with ski boots: a good bike that’s not properly fitted is only half as enjoyable. A saddle at the wrong height puts strain on your knees, incorrect tyre pressure reduces grip, and unadjusted suspension bounces or bottoms out. Here are the basic adjustments you should check before setting off on a hire bike, whether it’s a mountain bike or an e-bike.
1. The size of the frame
It all starts here. That’s why we ask for your height when you book. As a guide, when standing on the bike with both feet on the ground, there should be a little space between your crotch and the top tube. And when seated, with your hands on the handlebars, you shouldn’t be either too stretched out or too hunched over.
2. The height of the saddle
It’s the adjustment you notice most on your legs.
- Sit down and place your heel on the pedal at its lowest point. Your leg should be almost straight.
- When cycling normally, using the front of your foot, your knee will be slightly bent. That’s the right height for climbing and riding on flat ground.
- On a descent, lower it. A low saddle allows you to shift your body weight backwards. Many mountain bikes have a dropper seatpost with a lever on the handlebars: use it.
If you feel pain at the front of your knee, the saddle is usually too low. If you wobble from side to side at the hips, it’s too high.
3. Tyre pressure
There is no one-size-fits-all figure: it depends on your weight, the tyre and the terrain. As a general rule:
- Higher pressure on wide tracks or tarmac: faster tyre.
- Less pressure on stony, root-covered trails: better grip and comfort.
- Never below or above the pressure indicated on the sidewall of the tyre.
When we hand over the bike to you, we’ll have already set the tyre pressure to the correct level for your weight and the type of route you tell us about.
4. The suspension (the ‘sag’)
Sag is the amount by which the suspension compresses when you get on the bike with your kit. If there’s too much sag, the bike bottoms out and loses effectiveness. If it’s too little, it bounces and doesn’t absorb shocks. On air forks and shock absorbers, this is adjusted via the air pressure, which is why it must be set using your weight, not that of the previous rider.
If your bike has a suspension lockout, engage it on long climbs on trails and always disengage it before descending.
5. Brakes and levers
The brake levers should be at a height that allows you to brake with one or two fingers without turning your wrist. Test the brakes before setting off, on level ground, and get used to how they feel: the disc brakes on a modern bike are very powerful.
6. On an electric bike, as well
- Check that the battery is charged and that you can read the display.
- Try out the assistance modes on flat ground before the first climb.
- An e-bike is heavier: the saddle and tyre pressure are even more important for riding it with ease.
If you’re not sure which one to choose, take a look at our comparison of electric bikes versus standard mountain bikes.
Before the first walk
Take a five-minute test ride near your accommodation: go up, go down, brake and change gears. If anything isn’t quite right, now’s the time to sort it out – not halfway up the mountain.
7. Saddle and handlebar position
As well as adjusting the height, the saddle can be moved forwards and backwards and tilted. To start with, set it horizontally. If you find yourself sliding forwards or putting too much weight on your hands, check the tilt. As for the handlebars, they should allow you to keep your arms slightly bent, never locked.
8. The frets and the pedals
If you use clipless pedals and are bringing your own shoes with cleats, please let us know when you book so we can find out which system you’re using. For most leisure rides, flat pedals with sturdy-soled shoes are more than enough and allow you to put your foot down easily.
A quick check before every ride
Taking a minute before you set off could save you a lot of hassle halfway through your journey:
- Tyres: press the tyres with your thumb to check that they are inflated.
- Brakes: squeeze the levers; they should provide firm braking before you reach the handlebar grip.
- Fastening points: check that the wheel axles and seat post are securely fastened.
- Change: shift up and down a couple of gears.
- Battery, if electric: fully charged and securely fitted.
Settings for children
On children’s bikes, the saddle should be at a height that allows the child to at least touch the ground with their toes, so that they feel safe when stopping. Also check that they can reach the brake levers easily and know how to use them before their first ride downhill.
Frequently Asked Questions
What size bike do I need based on my height?
It depends on the manufacturer, which is why we ask for your height when you book and assign you the appropriate size. When we deliver it, we’ll check with you to make sure it fits properly.
How high should the saddle be on a mountain bike?
With your heel on the pedal at its lowest point, your leg should be almost fully extended. On technical descents, it is best to lower it.
What is the tyre pressure on a mountain bike?
It depends on your weight, the tyre and the terrain. Lower pressure gives you better grip on trails; higher pressure means you’ll go faster on the track. Always stick to the limits marked on the tyre.
How do I know if the suspension is correctly adjusted?
When you get on the bike with your kit, the suspension should compress slightly (sag), without becoming stiff or compressing too much. It adjusts to your weight.
We’ll deliver your bike to your accommodation and adjust it for you: size, saddle, tyre pressure and suspension. Book your bike and get out on the road straight away.