The buckles on your ski boots aren’t there just to be tightened all the way up and then forgotten about. Each one has its own function, and the order in which you fasten them makes a big difference to how your foot sits in the boot. If you’ve ever ended the day with numb toes or a sore instep, the problem was probably not the boot itself, but how you fastened it.
The parts you are going to adjust
- Toe straps (usually two, over the toes and the instep): these secure the forefoot.
- Buckle on the boot shaft (usually two, on the leg): these are what transmit your movements to the ski.
- Velcro strap or power strap (at the very top): secures the upper against the shin and improves responsiveness.
The system that works
- The shoe fits the foot well: heel all the way back, no creases in the sock and the tongue centred.
- First, fasten the buckle on the shaft closest to the ankle. This is the one that holds the heel most securely in place. Fasten it tightly.
- Then the top buckle on the shaft, also tightened firmly but without cutting off the circulation.
- Then the ones on the foot, which are looser. They should provide support, not constrict. If you tighten them as much as possible, the toes won’t get any blood flow and will go cold.
- Finally, the Velcro, securely fastened around the shin.
Many skiers do exactly the opposite: they clamp their foot in too tightly and leave the binding loose. The result: their foot suffers and the boot doesn’t respond.
How tight to fasten each buckle
A simple rule: firm at the top, loose at the bottom. The buckles on the upper can be fastened at a point where you feel distinct pressure but no pain. Those on the foot should be fastened at the first point where the foot no longer moves.
Most boots have a small screw or ‘micro-adjustment’ on each buckle and several notches. If a buckle is too loose in one notch and too tight in the next, turn the screw half a turn rather than forcing it.
Adjust throughout the day
- Take it easy on long chairlifts or when stopping for a bite to eat. Your foot recovers and the warmth returns.
- Tighten it again as you start to go down. After an hour, your foot will settle in and you may need to tighten the boot a little.
- When walking, undo the buckles on the shaft and, if your boots have one, switch to walking mode. You’ll find it much more comfortable.
Signs that something isn’t properly closed
- Numb or cold toes: shoelaces tied too tightly.
- The heel lifts up: loose ankle buckle or boots that are too big.
- Pain in the shin: a twisted tongue, a crease in the sock or a loose cuff causing the leg to knock against it.
- Cramps in the arch of the foot: often caused by tightening the laces too much to compensate for a boot that is too big.
If they still hurt after you’ve adjusted them properly, don’t put up with it: the size or style isn’t right for you. We explain this in more detail in tips for a good boot fit.
How to use the micro-adjustment on the buckles
Almost all modern boots allow you to adjust each buckle in two ways:
- The notched ladder, where you hook the fastening. Each notch represents a significant increase in pressure.
- The screw on the fastener, which lengthens or shortens the hook slightly. Turning it half a turn brings it to the mid-point between two notches.
If you notice that one notch is too loose and the next one is too tight, the thread is your ally. And if you’re not sure how it works on your model, just ask us when you collect your material.
Walking mode and tilt adjustment
Many boots have a lever at the back of the upper that releases the binding for walking. Make sure it’s in ski mode before you set off: if it remains in walk mode, the boot won’t hold you in place when you’re going backwards and you’ll lose control.
Some boots also allow you to adjust the angle of the shaft or the width of the upper to accommodate wider calves. It’s best to make these adjustments carefully and with assistance the first time.
Fastening the children’s boots
Children’s boots usually have fewer buckles and sometimes just a single fastening at the back. The rules are the same: heel all the way in, plain socks and the bootleg fastened securely. Check mid-morning to make sure they haven’t come loose and that their feet aren’t cold: often, ‘I don’t want to ski any more’ is just a numb foot.
Frequently Asked Questions
Which ski boot buckle do you fasten first?
The part of the boot shaft closest to the ankle, as this is what secures the heel. Then the upper part of the boot shaft, followed by the parts around the foot, and finally the Velcro fastening.
Do all the buckles need to be tightened as much as possible?
No. The shin strap does need to be tight, but the foot straps should only be tight enough to stop your foot from moving. If you tighten everything as much as possible, you’ll cut off the circulation.
Why do my fingers go numb when I’m wearing my ski boots?
This is almost always caused by the buckles on the foot being too tight or by wearing thick socks. Loosen the forefoot area and wear thin socks. For more causes, see foot pain when wearing ski boots.
Should I loosen my boots on the chairlift?
On long ski lifts and when you stop for a bite to eat, yes: your foot recovers and the warmth returns. Remember to fasten them up again before heading back down.
When we bring you the material, we’ll show you how to fasten your boot onto your own foot. Book your material and start the day with your boots properly fastened.